Wire Mesh Vibration Dampers
We are very happy to announce the recent development of several types of Wire Mesh Vibration Dampers using a cushion knitted stainless steel wire mesh. With the use of Wire Mesh Vibration Dampers we increase the damping factor and limit the amplification at the natural frequency.
Wire Mesh Vibration Dampers can be used for the vibration isolation of mechanical equipment in military, marine, avionics applications, in tough environments. It should be noted that Wire Mesh Vibration Dampers are resistant in normal liquids and dust.
It is recommended that the product is used for mechanical Noise & Vibration isolation in:
* Vibrating equipment subjected to seismic events.
* Vibrating equipment with significant center of mass alternations
* High win loads or other external forces are applied.
See below some of our wire mesh vibration dampers :
Vibro-3D.wm – The new Vibro-3D.wm is a wire mesh vibration dampers that offers multi-directional support. It can be an ideal solution for shock-absorbing and vibration – isolation applications. It’s internal knitted stainless steel wire mesh is formed into a resilient cushion. It can be used wherever environmental conditions could damage or destroy conventional rubber pads. Vibro-3D.wm is specially designed to sustain impulsive loads in all three axis (x, y, z). It is recommended for applications in extreme temperature and environmental conditions.
Vibro-AMR.wm – A restrained single spring mount with internal knitted stainless steel wire mesh. This metal cushion inside the spring increases the damping factor and limits the vibration at the natural frequency. At its base, Vibro -AMR.wm is a galvanized metal plate with adequate thickness covered by a special rubber pad, resistant to outdoor conditions (not applicable in high temperature applications). This rubber profile offers better isolation efficiency at high frequencies, that can be transmitted through its metal structure.
Vibro-MSR.wm – Is a multi spring restrained mount with relative limit stops and internal stainless steel wire mesh cushion.The metal plates are protected from oxidation with polyester powder paint. On the bottom it can be fixed with the use of M8 pass -through bolts.
Vibro-MS.wm – A wire mesh vibration damper, with multiple free standing springs. Within the internal diameter of the coil spring there is a resilient cushion knitted stainless steel wire mesh, which is the differentiation between the Vibro-MS and the equivalent wire mesh vibration damper VIBRO-MS.wm. This wire mesh vibration damper has multiple free standing springs in order to be suitable for a wide range of machinery. The springs are fixed with an innovative fastening system. The internal metal cushion reduces the amplification at the natural frequency and increases the damping factor.
Vibro-AM.wm – A free standing single spring anti-vibration mount, with internal knitted stainless steel wire mesh. This metal cushion inside the spring increases the damping factor and limits the vibration at the natural frequency. At its base, there is a galvanized metal plate with adequate thickness covered by a special rubber pad, resistant to outdoor conditions (not applicable in high temperature applications).
For more information please visit here and a free of charge technical selection of the most appropriatewire mesh vibration dampers for your project, do not hesitate to contact our technical department.